Gatorade Maker

Overview

Have you ever tried a Gatorade mix and you end up with not enough powder or too much water? The solution to this would be "The Gatorade Maker". This project aims at creating a system that pours powder and water to make a Gatorade mix. The user will enter how many ounces of Gatorade they desire. The system will dispense the powder and water in an appropriate amount in the glass. This will allow you to be worry-free about the accuracy of the water and powder you will have in your drink.

Team Members

• Fazeela Kazmi
• Jacob Pinter
• Natalie Ng (TA)

Objectives

• A successful project would allow the system to accurately dispense the powder and water in a glass, in an amount needed for the mix the user chooses off a menu.

Challanges

• learning to code with Arduino
• How to dispense ingredients cleanly/neatly/accurately
• The building of the dispenser
• Keeping up with the schedule

Gantt Chart

Budget

• Tubing $7.99
• Buttons $4.95
• Stepper Motor
• Auger
• Tank for Water
• Cylinder Container for Powder
• Arduino Uno Rev- given
• Solenoid Valve $9.95
• Solderless Bread Board $6.95
• TIP120 Darlington Transistor $.95
• 1k Ohm Resistor $1.00
• Diode $.15
• Hookup Wires $6.95
• Load sensor karlsson robotics 50 kg $9.95 http://www.kr4.us/load-sensor-50kg.html