Potentiometer + Arduino

From ESE205 Wiki
Revision as of 21:02, 18 August 2018 by Ethanshry (talk | contribs)
Jump to navigation Jump to search

Goal:


  • Wire a potentiometer to Arduino.

What You'll Need:


Hookup:


  • The potentiometer can be used as a variable resistance. Here it will be used to control an electrical potential (i.e., voltage), which the Arduino will be able to read via the analogRead(). Consequently, the potentiometer should be connected to an analog input pin.
  • To hookup a potentiometer properly, we first insert three pins on the bottom of this potentiometer to Arduino board. Then use one jumper wire to connect an anode pin to a voltage pin (5v). Also a cathode should be connected to a ground pin. For the potentiometer part, the top and bottom pins will be connected to one positive and one negative pins. The middle pin of the potentiometer goes to one analog pin.
  • After you have finished all these steps, you should have something look like this:
alt text