Difference between revisions of "Prototype Board Use"
Jump to navigation
Jump to search
Line 1: | Line 1: | ||
=== Prep === | === Prep === | ||
---- | ---- | ||
− | + | '''Materials''' | |
− | + | *Prototype board | |
− | + | *Soldering iron and solder wire | |
− | + | *Extra wires | |
− | + | *Components you're connecting to the board | |
− | + | '''Prepare layout''' | |
− | + | *Think about how to make your layout efficient | |
− | + | *Sketch layout | |
− | + | '''Practice''' | |
− | + | *If you've never soldered before, practice on a few extra holes in your prototype board before you try it with your components | |
=== Soldering === | === Soldering === |
Revision as of 22:16, 17 April 2017
Prep
Materials
- Prototype board
- Soldering iron and solder wire
- Extra wires
- Components you're connecting to the board
Prepare layout
- Think about how to make your layout efficient
- Sketch layout
Practice
- If you've never soldered before, practice on a few extra holes in your prototype board before you try it with your components
Soldering
The Basics
- Place the soldering iron in its stand and heat it to about 650 to 700 degrees Fahrenheit.
- Touch the tip of the soldering iron to the component's wire for a few seconds, then touch the solder to the other side of the component's wire (the solder should melt around the hole the component's wire is in).
- As soon as there's a strong connection, remove the soldering iron tip from the wire.
Be careful with how long the tip is on the component, as components can overheat.
Tips for Prototype Boards
- To connect multiple components in series or parallel, drag the top of the soldering iron across the already-soldered holes.
- Put all the components in their places before starting to solder to make sure everything fits right. Then solder everything in place before connecting between components.
TO BE CONTINUED