To constrain two part instances with parallel edges:

From the main menu, select ConstraintParallel Edge.

Tip:  You can also apply the parallel edge constraint using the tool in the Assembly module toolbox. For a diagram of the tools in the Assembly toolbox, see “Using the Assembly module toolbox,” Section 13.8.

ABAQUS/CAE displays prompts in the prompt area to guide you through the procedure.

Select a straight edge from the part instance that will move and a straight edge from the part instance that will remain fixed, as shown in the following figure:



In addition, to selecting an edge or a datum axis, you can also select one of the axes of a datum coordinate system.

ABAQUS/CAE displays arrows along the selected edges.

When ABAQUS/CAE prompts you to select the edge from the fixed part instance, you can select a datum axis that was created in either the Part or Assembly module. In contrast, when you select the edge from the movable part instance, you can select a datum axis that was created only in the Part module.

From the buttons in the prompt area, do one of the following:

Click OK to accept the direction of the arrow along the edge of the movable instance.

Click Flip to reverse the direction of the arrow along the edge of the movable instance, and click OK.

ABAQUS/CAE positions the movable part instance so that the two edges are parallel and the arrows point in the same direction. The orientation of the fixed part instance remains unchanged. The effect of changing the direction of the arrow is illustrated in the following figure:



If the parallel edge constraint conflicts with existing constraints, ABAQUS/CAE displays an error message and cancels the operation. To avoid the conflict, you can try reversing the selection of the part instance that will move and the part instance that will remain fixed. Alternatively, you can convert the existing constraints to an absolute position and reapply the parallel edge constraint.