Shell problems generally fall into one of two categories: thin shell problems and thick shell problems. Thick shell problems assume that the effects of transverse shear deformation are important to the solution. Thin shell problems, on the other hand, assume that transverse shear deformation is small enough to be neglected. Figure 5–5(a) illustrates the transverse shear behavior of thin shells: material lines that are initially normal to the shell surface remain straight and normal throughout the deformation. Hence, transverse shear strains are assumed to vanish (). Figure 5–5(b) illustrates the transverse shear behavior of thick shells: material lines that are initially normal to the shell surface do not necessarily remain normal to the surface throughout the deformation, thus adding transverse shear flexibility ().

There are three different classes of shell elements in ABAQUS, distinguished by the element's applicability to thin and thick shell problems. General-purpose shell elements are valid for use with both thick and thin shell problems. Furthermore, all general-purpose shell elements in ABAQUS consider finite membrane strains. In certain cases, for specific applications, enhanced performance can be obtained by using special-purpose shell elements. All special-purpose shell elements assume finite rotations; however, they assume small strains. The special-purpose shell elements fall into two categories: thin-only shell elements and thick-only shell elements. The thin-only shell elements enforce the Kirchhoff constraint; that is, plane sections normal to the midsection of the shell remain normal to the mid-surface. The Kirchhoff constraint is enforced either analytically in the element formulation (STRI3) or numerically through the use of a penalty constraint. The thick-only shell elements are second-order quadrilaterals that may produce more accurate results than the general-purpose shell elements in small-strain applications where the loading is such that the solution is smoothly varying over the span of the shell. Table 5–1 lists the three categories of shell elements in ABAQUS.

To decide if a given application is a thin or thick shell problem, we can offer a few guidelines. For thick shells transverse shear flexibility is important, while for thin shells it is negligible. The significance of transverse shear in a shell can be estimated by its thickness-to-span ratio. A shell made of a single isotropic material with a ratio greater than 1/15 is considered “thick”; if the ratio is less than 1/15, the shell is considered “thin.” These estimates are approximate; you should always check the transverse shear effects in your model to verify the assumed shell behavior. Since transverse shear flexibility can be significant in laminated composite shell structures, this ratio should be much smaller for “thin” shell theory to apply. Composite shells with very compliant interior layers (so-called “sandwich” composites) have very low transverse shear stiffness and should almost always be modeled with “thick” shells; if the assumption of plane sections remaining plane is violated, continuum elements should be used. See “Shell section behavior,” Section 15.6.4 of the ABAQUS Analysis User's Manual, for details on checking the validity of using shell theory.

Transverse shear force and strain are available for general-purpose and thick-only shell elements. For three-dimensional elements, estimates of transverse shear stress are provided. The calculation of these stresses neglects coupling between bending and twisting deformation and assumes small spatial gradients of material properties and bending moments.