Difference between revisions of "Fanuc How Tos, FAQ, etc."

Revision as of 19:06, 26 September 2014

View Alarm Screen
- Menu -> Alarms -> Alarm Log
Use Teaching Pendant
- Keyed control knob in T1 position
- Teaching Pendant in ON position
- Press Deadman switch in half way to do anything
Move robot with Teaching Pendant
- Press Coord until Joint Frame is selected
- Press Shift and any of the blue motion buttons to move the 6 joints
- Press +%/-% to adjust the speed
Open and Close Gripper
- Menu -> I/O -> Robot
- Arrow down to Gripper
  - F4 (On) Opens
  - F5 (Off) Closes
Clear Errors on Teaching Pendant
- Push Deadman switch in halfway
- Hold Shift and push Reset on TP
"SRV-038 Pulse Mismatch" Error
"SRVO-062 BZAL Alarm" Error
- Replace 4 C Cell batteries in battery compartment
- Re-Calibrate

Move all 6 joints to line up the registration marks (add photos)
- Joint 4 doesn't have a mark - just line it up flush
- Joint 6 doesn't have a mark - just line up screws
If you get "No Pulse Detected" error on a joint, then you just manually move the joint and then put it back.
Menu -> Next -> System -> Mastering/Cal
- Click on Zero Master
You should get warning "SYST-212 Need to apply DCS parameter"
Menu -> Next -> System -> DCS
- Enter Code 1111
Click OK
Cycle Power
Test by putting in World Frame and make sure the tip moves in the desired X,Y or Z directions

@@ Line 13: / Line 13: @@
 ** Menu -> I/O -> Robot
 ** Arrow down to Gripper
+*** F4 (On) Opens
-* Clear Errors in general
+*** F5 (Off) Closes
+* Clear Errors on Teaching Pendant
 ** Push Deadman switch in halfway
 ** Hold Shift and push Reset on TP