Difference between revisions of "Adafruit HUZZAH ESP8266 breakout"
From ESE497 Wiki
Jump to navigationJump to searchLine 16: | Line 16: | ||
** Upload program. | ** Upload program. | ||
** Open the serial monitor to see IP and messages from adafruit web server. Make sure the serial data rate is set to 115200 baud. | ** Open the serial monitor to see IP and messages from adafruit web server. Make sure the serial data rate is set to 115200 baud. | ||
+ | * UDP Example | ||
+ | ** http://virtualrouterplus.com/ |
Revision as of 20:04, 25 February 2016
- Buy from AdaFruit (https://www.adafruit.com/products/2471)
- Don't forget cable (https://www.adafruit.com/product/954)
- Overview doc (https://learn.adafruit.com/adafruit-huzzah-esp8266-breakout/overview)
- Follow instructions for adding support to the Arduino Environment for the ESP8266 chip (https://github.com/esp8266/Arduino)
- Connect USB Console cable to board (https://learn.adafruit.com/adafruit-huzzah-esp8266-breakout/using-arduino-ide)
- Remember, before every download you have to:
- Hold down the GPIO0 button, the red LED will be lit
- While holding down GPIO0, click the RESET button
- Release RESET, then release GPIO0
- When you release the RESET button, the red LED will be lit dimly, this means its ready to bootload
- (from https://learn.adafruit.com/adafruit-huzzah-esp8266-breakout/using-arduino-ide)
- Copy the Blink Test code from https://learn.adafruit.com/adafruit-huzzah-esp8266-breakout/using-arduino-ide to test. Red light should blink.
- Copy the Connecting via WiFi code from https://learn.adafruit.com/adafruit-huzzah-esp8266-breakout/using-arduino-ide.
- Change ssid to "wustl-guest-2.0"
- Change password to ""
- Upload program.
- Open the serial monitor to see IP and messages from adafruit web server. Make sure the serial data rate is set to 115200 baud.
- UDP Example