Difference between revisions of "Matlab Fanuc Robot Control"

From ESE497 Wiki
Jump to navigationJump to search
Line 1: Line 1:
 
Example of moving the robot to a specific location from Matlab:
 
Example of moving the robot to a specific location from Matlab:
 +
 
[[File:IMG_1188.JPG|400px]]
 
[[File:IMG_1188.JPG|400px]]
 
* Place marker and metal can exactly as shown above
 
* Place marker and metal can exactly as shown above

Revision as of 18:42, 27 October 2015

Example of moving the robot to a specific location from Matlab:

IMG 1188.JPG

  • Place marker and metal can exactly as shown above
  • Turn on Robot
    • Menu -> Setup -> Frames
      • Verify Tool Frame 1 is set to [0,0,0]
      • Verify Tool Frame 2 is set to [0,0,95.3] so that the TCP is at the end of the gripper
    • Select -> LV_COM_FRM to select the Teaching Pendant Program to run the robot to PC communication program
    • Turn Teaching Pendant to OFF
    • Insert key into Controller and turn to T1 position
    • Press Shift -> Reset on Teaching Pendant to clear any errors
    • Press Green Start button on Controller
  • Download and extract MatlabLabVIEWFanuc.zip
  • Open and run LabVIEW\MatlabLabVIEWFanuc.vi
  • Open and run matlab\MatlabLabVIEWFanuc.m

<mediaplayer width=720 height=504>FILE:2015-10-02_16.53.54.flv</mediaplayer>