View source for Data Acquisition Basics

* [[media:LabVIEW_Introduction.pdf|LabVIEW Tutorial]]
** Code up examples in LabVIEW for slides 11, 14, 27, 31, 36, 38, 41. Put each one in a separate VI and demo to me or T/A.
** Configure LabVIEW options as shown in slides 15-17
** Exercises 1,2,3
* Homework 3 - Finish Exercises
* Assign Project1 - Simulation
* Homework 4 - Finish ComputeAngle.vi (in Project1 -> RoboticSensing.zip -> micSourceLocator.lvproj -> My Computer -> ComputeAngle.vi) and ComputeIntersection.vi
* Additional Resources
** Conditionally append values to an array in a loop
** [http://cnx.org/content/m12220/latest/ How to Create and Array on the Front Panel]
** [http://www.ni.com/academic/students/learnlabview LabVIEW 101]
* [[media:Data_Acquisition_Basics.pdf|Data Acquisition Basics]]
** Homework 5 - Finish exercise
** Homework 6 - Connect wires from A00 and AO1 to AI0+ and AI1+ (remove wire from Banana A to AI0+). Make sure that the Prototyping Power is on. Modify your vi from Homework 5 to collect samples from both AI0 and AI1. Then open  [[media:DelayedChirp2DAC.zip|DelayedChirp2DAC.vi]] and run this vi. You shouldn't modifiy DelayedChirp2Dac.vi. Run your modified Homework 5 vi and zoom in in the time and frequency domain to examine the waveforms in detail. Describe in detail what you see. Measure the difference in time between both channels. Hint: Start and stop your Data Acquisition vi until the entire signal is in the middle of the buffer.