Difference between revisions of "Prototype Board Use"

From ESE205 Wiki
Jump to: navigation, search
Line 1: Line 1:
=== Prep ===
+
== Prep ==
 
----
 
----
 
'''Materials'''
 
'''Materials'''
Line 12: Line 12:
 
*If you've never soldered before, practice on a few extra holes in your prototype board before you try it with your components
 
*If you've never soldered before, practice on a few extra holes in your prototype board before you try it with your components
  
=== Soldering ===
+
== Soldering ==
 
----
 
----
  

Revision as of 16:17, 17 April 2017

Prep


Materials

  • Prototype board
  • Soldering iron and solder wire
  • Extra wires
  • Components you're connecting to the board

Prepare layout

  • Think about how to make your layout efficient
  • Sketch layout

Practice

  • If you've never soldered before, practice on a few extra holes in your prototype board before you try it with your components

Soldering


The Basics

  • Place the soldering iron in its stand and heat it to about 650 to 700 degrees Fahrenheit.
  • Touch the tip of the soldering iron to the component's wire for a few seconds, then touch the solder to the other side of the component's wire (the solder should melt around the hole the component's wire is in).
  • As soon as there's a strong connection, remove the soldering iron tip from the wire.

Be careful with how long the tip is on the component, as components can overheat.

Tips for Prototype Boards

  • To connect multiple components in series or parallel, drag the top of the soldering iron across the already-soldered holes.
  • Put all the components in their places before starting to solder to make sure everything fits right. Then solder everything in place before connecting between components.

TO BE CONTINUED