Difference between revisions of "3D Printer"
(Created page with "We have a 3D printer model ''Ultimaker 2 Extended'' in our lab. = Manuals = == User Manual == The user manual can be downloaded in multiple languages at https://ultimaker.co...")
Revision as of 11:49, 23 December 2015
We have a 3D printer model Ultimaker 2 Extended in our lab.
The user manual can be downloaded in multiple languages at https://ultimaker.com/en/support/view/16554-user-manual.
Your packaging may differ slightly from that shown, as the new packaging is being rolled out as it becomes available. However, should any accessories be missing please contact us immediately. PLEASE NOTE: The filament guide is no longer being included and is not necessary for operation, so please disregard any references to this part.
Basic Printer Calibration
IMPORTANT: If you're getting started with 3D printing, we strongly recommend using the included reel of PLA. Due to its low extrusion temperature and good platform adherence, PLA experiences much less warping than other materials. Using PLA when you're learning to use your Ultimaker allows you to build a solid understanding of the printing process and will increase your rate of successful prints - and also your enjoyment - down the road.
Please also note that the included glue stick is generally regarded as unnecessary for PLA since your printer uses a heated build platform, but can be beneficial for CPE and ABS. If you do decide to use it, apply an extremely small amount with a moist paper towel - if you can see the glue, it's too much. Once you heat the build platform, the remaining moisture will evaporate, leaving behind a very thin layer of glue.
Cura Slicing Software
Cura is the open-source slicing software used by the Ultimaker 2, and can be downloaded here:
When updating to a newer version of the software, it is also important to check that your printer is loaded with the most up-to-date version of firmware:
The software has recently gone through a major update with version 15.06, which is still in the beta phase and is being updated continually. Operational information for Cura version 15.06 can be found at:
Because this version is a beta in active development, you may experience performance issues. If you prefer to use the latest stable version of the software, please download version 15.04.2. Information for this version can be found at:
Basic Printer Troubleshooting
The most common issues experienced by new users are related to bed leveling and adhesion, and there are a few tips which can help improve bed adhesion:
If a print does not complete successfully or there is no material being extruded, there may be an issue with the filament. The first point to check is the feeder on the back of the printer to ensure that the filament has not been ground down. If this is not the case, there may be a nozzle clog. This can usually be solved using a simple manual feeding process known as the “Atomic method”:
Advanced Printer Troubleshooting/Maintenance
Ultimaker’s official partner 3DVersktan has developed a number of useful guides, which can be found at the following link:
Installing the Olsson Block is considered an intermediate to advanced activity. If you're just getting started with Ultimaker, we advise using the stock nozzle+heaterblock until you're familiar with the printer, then attempting the upgrade.
For more information on Olsson Block installation, please visit http://www.ultimaker.com/olssonblock