Gatorade Maker

Overview

Have you ever tried a Gatorade mix and you end up with not enough powder or too much? The solution to this would be "The Gatorade Maker". This project aims at creating a system that pours powder and water to make a Gatorade mix. The user will choose from 3 preset options. These options are sweet, Gatorade recommended, and mild. Also, 3 preset amounts of Gatorade. The system will dispense the powder and water in an appropriate amount in the glass. This will allow you to be worry-free about the accuracy of the water and powder you will have in your drink.

""Weekly log""

Team Members

• Fazeela Kazmi
• Jacob Pinter
• Natalie Ng (TA)

Objectives

• A successful project would allow the system to accurately dispense the powder and water in a glass, in an amount needed for the mix the user chooses off a menu.

Challanges

• learning to code with Arduino
• How to dispense ingredients cleanly/neatly/accurately
• The building of the dispenser
• Keeping up with the schedule

Gantt Chart

Budget

• Tubing $7.99
• Buttons $4.95
• Stepper Motor $13.99
• Auger- 3D Print
• Tank for Water $7.26
• T Shaped PVC Pipe (Holds Auger) $2.23
• Arduino Uno Rev- given
• Solenoid Valve $9.95
• Solderless Bread Board $6.95 (x2)
• TIP120 Darlington Transistor $.95
• 1k Ohm Resistor $1.00
• Diode $.15
• Hookup Wires $6.95
• Load Cell 5 kg and Converter $8.50
• Motor Shield $22.84
• Alligator clips - $7.70
• 9V battery - $5.47
• Electric Selenoid valve- [1] - $22.99

• Total: $136.82