Difference between revisions of "OpenCV4"
Jump to navigation
Jump to search
| Line 19: | Line 19: | ||
Following these step to [https://www.dexterindustries.com/howto/installing-the-raspberry-pi-camera/ set up your camera]. | Following these step to [https://www.dexterindustries.com/howto/installing-the-raspberry-pi-camera/ set up your camera]. | ||
| − | Note: Ignoring GoPiGo installation. | + | *Note: Ignoring GoPiGo installation. |
Revision as of 19:21, 6 December 2018
Contents
Overview
This is a tutorial on how to install OpenCV4 and use camera module.
Materials/Prerequisites
- Raspberry Pi
- Raspberry Pi Camera
Process
Install OpenCV
Follow these instructions to install OpenCV onto your Raspberry Pi using the terminal.
- Important note: don't do
make-j4. It may freeze so it best to just domakeormake-j1.
After you have successfully installed OpenCV, you will be able to use import cv2. If you do it on the terminal, you want to put in these code source ~/.profile and then workon cv.
Capturing image
Following these step to set up your camera.
- Note: Ignoring GoPiGo installation.
In order to capture image, follow these instruction
Note:
- Use
sleep(measured in seconds) to create a delay between the preview:time.sleep(seconds)
- Another way to enable your camera is: go to the terminal → type in
sudo raspi-config→ selectEnable Camera→ press Enter → selectFinish→ reboot and log back on to the Raspberry Pi.
Authors
- Nhut Dang
- Robert Goodloe
- Ethan Shry(TA)
Fall 2018
