This section describes the tools that you can use to create a datum point. The following methods are covered:
“Creating a datum point by entering its coordinates,” Section 40.6.1
“Creating a datum point at an offset from a selected point,” Section 40.6.2
“Creating a datum point midway between two points,” Section 40.6.3
“Creating a datum point at a specified distance from two edges,” Section 40.6.4
“Creating a datum point by entering an edge parameter,” Section 40.6.5
“Creating a datum point by projecting a point on a face,” Section 40.6.6
“Creating a datum point by projecting a point on a line,” Section 40.6.7