When you enter the Sketcher and either create a new sketch or edit an existing sketch, ABAQUS/CAE displays a sheet in the current viewport on which you sketch. In addition, the triad in the lower-left corner of the viewport indicates the orientation of the part or the assembly relative to the Sketcher sheet. The sheet is always square, and its height and width are determined by the sheet size. ABAQUS/CAE determines the sheet size and the location of the origin, depending on what you are sketching:
If you are sketching the base feature of a new part, the sheet size is the same as the approximate size of the part that you provided when you created the part. The origin of the sheet is located at the origin of the part's coordinate system. Similarly, if you are creating a stand-alone sketch, the sheet size is the same as the approximate size of the sketch that you provided when you created the sketch.
If you are adding a feature to a part or to the assembly, the default sheet size depends on the size of the face on which you are sketching. The origin of the sheet is located at the centroid of the selected face. If you selected a datum plane as the sketching plane, the origin of the sheet is located at the center of the part or assembly; the sheet size depends on the total size of the part or assembly.
from the Sketcher toolbox. You may need to use the magnify tool 
to view the entire Sketcher sheet within the viewport.ABAQUS/CAE overlays the sheet with a grid of invisible grid points to help you position the cursor as you draw, move, resize, or reshape objects. By default, when you move the cursor near a grid point, the cursor automatically moves, or snaps, to the point. This behavior allows you to easily position the cursor precisely on a grid point while also providing you with full control when the cursor is not close to any grid points. If it is more convenient, you can disable the snapping behavior so that you have full control over the cursor. To help you visualize the grid points underlying the Sketcher grid, ABAQUS/CAE displays visible grid lines that pass through the grid points at a selected interval; for example, every other grid point.
For example, Figure 19–2 shows a sheet whose size is set to 100 and a grid whose spacing is set to 10 units.
Every grid line in Figure 19–2 is visible; the description, “1 out of x,” corresponds to the customization option that allows you to instead display 1 out of 2 grid lines (every other), 1 out of 3 grid lines (every third), etc. In addition, the Sketcher displays dashed lines along the grid indicating the X- and Y-axes of the sketch; the lines intersect at the origin of the sketch.You can customize the appearance and behavior of the grid by choosing the spacing of grid points, the spacing of the visible grid lines that overlay the grid points, and the sheet size. You can also realign the grid relative to the sketch by moving the origin of the grid and by rotating the grid. Your sketch can extend beyond the Sketcher grid; however, if you find that you need to sketch outside the grid, it is recommended that you increase its size to include the entire sketch. If you change the grid origin or rotation, the Sketcher displays cursor coordinates in two forms as you continue to modify the sketch. Grid coordinates indicate the cursor position using the new grid origin or rotation; sketch coordinates indicate the position based on the original grid location.
The analysis of your model can be affected by a loss of precision if the coordinates of a part are far from the origin of the part. For example, after you import a sketch to create the base feature of a part, the sketch may be relatively far from the Sketcher origin; as a result, the part will be far from its origin. To improve precision, you may have to move the part closer to its origin by moving the sketch geometry closer to the origin of the Sketcher grid using the translate tool, 
. You should not move the origin of the sketch closer to the geometry. Moving the origin of the Sketcher grid closer to the sketch is a graphical convenience only and has no effect on the underlying precision of the coordinates.
