ABAQUS/CAE uses the following terms to describe the status of objects in particular steps:
Created
The object was created and becomes active in this step. The point in the step at which a prescribed condition becomes active depends on the amplitude variation associated with that step. For more information, see “Prescribed conditions” in “Procedures: overview,” Section 6.1.1 of the ABAQUS Analysis User's Manual.
Computed
The analysis products will compute the value of the object in this step.
Modified
The definition of the object has been modified in this step. The variation of a prescribed condition over the course of the step depends on the amplitude variation associated with that step.
Propagated
The object was created, modified, or computed in an earlier step of the analysis and continues to be active in this step.
Inactive
The object has been deactivated in this step or in a previous step. It will remain deactivated in all subsequent steps until you reactivate it. You cannot deactivate an object in the step in which it was created. The point in the step at which a prescribed condition becomes inactive depends on the amplitude variation associated with that step. For more information, see “Prescribed conditions” in “Procedures: overview,” Section 6.1.1 of the ABAQUS Analysis User's Manual.
You cannot deactivate fields; an inactive status for a field means that the field has been reset to the value specified in the initial step. The point in the step at which an object resumes its initial value depends on the amplitude variation associated with that step. For more information, see “Prescribed conditions” in “Procedures: overview,” Section 6.1.1 of the ABAQUS Analysis User's Manual.
Built into base state
Any active object created in a preceding general analysis step will be part of the base state and cannot be changed during the linear perturbation step.
Propagated from base state
Objects created in a previous general step will be part of the base state for this procedure but can be modified or deactivated by the user.
Deactivated from base state
Objects created in a previous general step are deactivated in this linear perturbation step. The deactivated state applies only to the linear perturbation step and does not propagate to the remaining steps.